Casio PV-S450 Instrukcja Użytkownika Pobierz pdf

127

Chapter

Data Communication

Data communications capabilities let you transfer data between two CASIO PV

Units, between a PV Unit and a BN-10/BN-20 Unit, or between a PV Unit and a

BN-10A/BN-20A/BN-40A Unit. You can also receive data from a CASIO SF,

CSF, or NX Series Unit, and communicate with a personal computer using PC

sync for Windows.

• See the manual that comes with PC sync for Windows for details on connecting

to a computer and setting up for communication.

Using the Cradle

The PV Unit comes with a cradle that helps to make data communications quicker

and easier. The following procedures describe how to attach the PV Unit to and

detach it from the cradle.

To connect the PV Unit to the cradle

1. Turn off PV Unit power.

2. Place the PV Unit onto the cradle.

• Gently but firmly press down on the PV Unit to ensure that it is inserted

into the cradle as far as it will go.

1 2 3 4 5 6 ... 12 13

Podsumowanie treści

Strona 1 - Data Communication

127Chapter11Data CommunicationData communications capabilities let you transfer data between two CASIO PVUnits, between a PV Unit and a BN-10/BN-20 Un

Strona 2 - 1. Turn off PV Unit power

136• Transferring data from the PV-S250/PV-S450 to the BN Unit causes alleuro symbols to be replaced by spaces.• The following shows the relationship

Strona 3

137Chapter 11 Data Communication4. Use an optional SB-90 9-9 pin connector to connect the PV Unit cradleto the other unit’s cable.To make communicatio

Strona 4

1386. Tap the buttons under Parity, Bit length, and BPS to make the settingsyou want.• Note that the settings you make here must match those of the co

Strona 5

139Chapter 11 Data CommunicationNotes• Data communication can be interrupted at any time by tapping Esc.This causes the message Stopped! to appear on

Strona 6

128To detach the PV Unit from the cradle1. Turn off PV Unit power.2. Angle the PV Unit forward as shown in the illustration, and then lift itstraight

Strona 7

129Chapter 11 Data CommunicationData Communications Between Two PV UnitsThis section describes how to set up and communicate between two PV Units.To c

Strona 8

1303. Tap the Menu Bar icon to display the menu bar, and then tap System –Data communication.4. Tap the button next to Pocket Viewer to specify the da

Strona 9

131Chapter 11 Data CommunicationTo receive data from the terminal unit on the host unit1. Perform steps 1 through 4 under “To send data from the host

Strona 10

132Notes• The above procedures can be used to send or receive all data in specificmodes only. You cannot send or receive individual data items.• Data

Strona 11 - Chapter 11 Data Communication

133Chapter 11 Data Communication4. Use an optional SB-90 9-9 pin connector to connect the PV Unit cradleto the BN Unit Mini Cradle.• All data communic

Strona 12

1344. Tap the button next to BUSINESS NAVIGATOR to specify the datacommunication configuration.5. Tap the button next to Send.6. Tap Set.7. Tap the ch

Strona 13

135Chapter 11 Data CommunicationTo receive data from the BN Unit on the PV Unit1. Perform steps 1 through 4 under “To send data from the PV Unit to th